![[+]](/dwicons/i_expand.gif)
The electronic pdf versions of the documents found through http://www.dnv.com/ are the officially binding versions. Copyright Det Norske Veritas.
|
| Sec.1: Introduction |
|
| Sec.2: Design Principles |
|
| Sec.3: Loads and Load Effects |
|
| Sec.4: Structural Categorisation, Material Selection and Inspection Principles |
|
| Sec.5: Structural Strength |
|
| Sec.6: Section Scantlings |
|
| Sec.7: Fatigue |
|
| Sec.8: Accidental Conditions |
|
| Sec.9: Weld Connections |
|
| Sec.10: Corrosion Control |
|
| Sec.11: Special Considerations for Column Stabilised Units |
|
| Sec.12: Special Considerations for Self-Elevating Units |
|
| Sec.13: Special Considerations for Tension Leg Platforms (TLP) |
![[-]](/dwicons/i_colpse.gif)
| Sec.14: Special Considerations for Deep Draught Floaters (DDF) |
|
| A: General |
|
| B: Non-Operational Phases |
|
| C: Structural Categorisation, Selection of Material and Extent of Inspection |
|
| D: Design Loads |
|
| E: Deformation Loads |
|
| F: Accidental Loads |
|
| G: Fatigue Loads |
|
| H: Combination of Loads |
|
| I: Load Effect Analysis in Operational Phase |
|
| J: Load Effect Analysis in Non-Operational Phases |
|
| K: Structural Strength |
|
|
|
| L100: General |
| L200: Operation phase for hull |
| L300: Non-operational phases for hull |
| L400: Splash zone |
| L500: Operation phase for deck or topside |
| L600: Non-operational phases for deck or topside |
|
| M: Accidental Condition |
|
| App.A: Cross Sectional Types |
|
| App.B: Methods and Models for Design of Column-Stabilised Units |
|
| App.C: Permanently Installed Units |
|
| App.D: Certification of Tendon System |