The electronic pdf versions of the documents found through http://www.dnv.com/ are the officially binding versions. Copyright Det Norske Veritas.

[Book] [Expand] [Collapse] [Search Forms] [Previous Section with Hits] [Next Section with Hits] [Clear Search] [Help]

Expand Search

D400: Latin symbols [Table of Contents] Ch.2: Technical Provisions

DNV-OS-C401 Fabrication and Testing of Offshore Structures

[-] Ch.1: Introduction
[-] Sec.1: Introduction
[-] D: Definitions
[-] D500: Greek symbols

Ch.1 Sec.1
D 500   Greek symbols

Ch.1 Sec.1 D
501   The following Greek symbols are used:
a = tubular joint angle 
d = measure of deformation compared to theoretical geometry 
li = length of area with acceptable location of the fatigue pre-crack 
n = Poisson's ratio 
s1 = largest compressive principal membrane stress 
s2 = principal membrane stress normal to s1 
y = ratio between principal stresses. 

D400: Latin symbols [Table of Contents] Ch.2: Technical Provisions