The electronic pdf versions of the documents found through http://www.dnv.com/ are the officially binding versions. Copyright Det Norske Veritas.
![[Table of Contents]](/dwicons/b_toc.gif)
|
DNV-OS-C501 Composite Components
|
Sec.1
C. How to use the standard
Sec.1
C 100 Users of the standard
Sec.1 C
101 The client is understood
to be the party ultimately responsible for the system as installed
and its intended use in accordance with the prevailing laws, statutory
rules and regulations.
Sec.1 C
102 The authorities are
the national or international regulatory bodies.
Sec.1 C
103 The contractor is understood
to be the party contracted by the client to perform all or part
of the necessary work needed to bring the system to an installed
and operable condition.
Sec.1 C
104 The designer is understood
to be the party contracted by the contractor to fulfil all or part
of the activities associated with the design.
Sec.1 C
105 The manufacturer is
understood to be the party contracted by the contractor to manufacture
all or part of the system. Two types of manufacturers can be distinguished:
the material manufacturers, which supply the composite material or
its constituents (i.e. resin, fibres) and the product manufacturers,
which fabricate all or part of the system.
Sec.1 C
106 The third party verifier is
an independent neutral party that verifies the design of a structure
or component.Sec.1
C 200 Flow chart of the standard
Fig. 1 Flow chart of the standard
Sec.1
C 300 How to use the standard
Sec.1 C
301 All users should go
through section 1 and section 2 describing
the scope of the standard and the design principles.
Sec.1 C
302 The client and contractor(s) should specify the
Design Premises according to section 3.
Sec.1 C
303 The design analysis should be performed by the designer according to section 6, section
7, section 8, section 9 and section
10. The main input for the Design Report should come out
of these sections.
Sec.1 C
304 The contractor(s) and manufacturer(s) should specify the
fabrication according to section 11.
Sec.1 C
305 The client and contractor(s) should specify the
installation and repair procedures according to section 12.
Sec.1 C
306 The third party verifier should
verify that the design documentation is according to the requirements
of section 2E.
![[-]](/dwicons/i_colpse.gif)