![[+]](/dwicons/i_expand.gif)
The electronic pdf versions of the documents found through http://www.dnv.com/ are the officially binding versions. Copyright Det Norske Veritas.
|
| Sec.1: General |
|
| Sec.2: Design Philosophy and Design Principles |
![[-]](/dwicons/i_colpse.gif)
| Sec.3: Design Input |
|
| A: Introduction |
|
| B: Product specifications |
|
| C: Division of the product or structure into components, parts and details |
|
| D: Phases |
|
| E: Safety and service classes |
|
| F: Functional requirements |
|
| G: Failure modes |
|
| H: Exposure from the surroundings |
|
| I: Loads |
|
| J: Environment |
|
| K: Combination of load effects and environment |
| K100: General |
| K200: Load effect and environmental conditions for ultimate limit state |
| K300: Load effect and environmental conditions for time-dependent material properties |
|
| K500: Direct combination of loads |
|
| Sec.4: Materials - Laminates |
|
| Sec.5: Materials - Sandwich Structures |
|
| Sec.6: Failure Mechanisms & Design Criteria |
|
| Sec.7: Joints and Interfaces |
|
| Sec.8: Safety-, Model- and System Factors |
|
| Sec.9: Structural Analysis |
|
| Sec.10: Component Testing |
|
| Sec.11: Fabrication |
|
| Sec.12: Operation, Maintenance, Reassessment, Repair |
|
| Sec.13: Definitions, Abbreviations & Figures |
|
| Sec.14: Calculation Example: Two Pressure Vessels |
|
| App.A: Check-lists for Design Input |
|
| App.B: Lay-up and laminate specification |
|
| App.C: Test methods for laminates |
|
| App.D: Test methods for sandwich materials |
|
| App.E: Tables of Safety Factors |
|
| App.F: Example for representative data Stitch-bonded unidirectional (UD) plies - E glass polyester |
|
| App.G: Example for representative data Unidirectional carbon tape AS4 12k |
|
| App.H: Example for Representative Data: Unidirectional Carbon Tapes made of TPW tape with "5631" fibres |
|
| App.I: Example for representative data Unidirectional carbon tape TPW 0434 Prepreg |