DET NORSKE VERITAS
TYPE APPROVAL CERTIFICATE


CERTIFICATE NO. S-5594

This Certificate consists of 5 pages

This is to certify that the

Winch, Brake

686.60

with type designation(s)

Hägglunds Bandbrakes and Brake Cylinder

Manufactured by

Hägglunds Drives Productions AB

Mellansel, Sweden

is found to comply with

Standard for Certification 2.22 Lifting Appliances, 2008

Application

Parking and emergency brakes: Max. pressure in brake/cylinder: 250 bar. Max.braking torque: Type BA-43: 73500 Nm - Type BA-63: 96400 Nm - Type BA-84: 195500 Nm - Type BA-85: 195599 Nm.

Place and date

 

This Certificate is valid until

Høvik, 2009-02-13

 

2013-06-30

for Det Norske Veritas AS

   
     
     
 

Per Arild Åland

 

Local Office

 

Lap Van Duong

 

Head of Section

DNV Stockholm

Surveyor

Product description

Bandbrakes BA-43/BA-63, BA-84, BA-85

Brake Cylinder BC1

Application/Limitation

Automatic braking is achieved when the operating device is brought to zero or braking position. When the hydraulic pressure fails, spring to be applied to obtain the necessary brake torque, which is not to be less than 80% in excess of maximum service torque exerted by the load being regarded as static load.

For calculations of the braking capacities in the type approval a friction coefficient of 0.3 is used.

The brakes are type approved as single acting brakes only.

Nominal braking torque = Maximum braking torque / 1.8

The design dynamic factor to be reviewed in each case according to DNV's "Standard for Certification 2.22 Lifting Appliances, Ch. 2, Sec. 5, B300" as far as applicable.

Each unit to be surveyed and product certificate to be issued by the surveyor.

Product, material and test certificate to accompany each product/delivery.

Type Approval documentation

Tests carried out

Test to be carried out of each product ensuring braking torque to be obtained.

Marking of product

The product to be marked with manufacturer's name or trademark and type number identification.

Certificate retention survey

For retention of the Type Approval, Det Norske Veritas' representative shall carry out biennial Product Audits if regular certification no longer takes place.

END OF CERTIFICATE


Notice: This Certificate is subject to terms and conditions overleaf. Any significant change in design or construction may render this Certificate invalid.

If any person suffers loss or damage which is proved to have been caused by any negligent act or omission of Det Norske Veritas, then Det Norske Veritas shall pay compensation to such person for his proved direct loss or damage. However, the compensation shall not exceed an amount equal to ten times the fee charged for the service in question, provided that the maximum compensation shall never exceed USD 2 million.In this provision "Det Norske Veritas" shall mean the Foundation Det Norske Veritas as well as all its subsidiaries, directors, officers, employees, agents and any other acting on behalf of Det Norske Veritas.


DET NORSKE VERITAS AS · VERITASVEIEN 1, 1322 HØVIK, NORWAY · TEL: (+47) 67 57 99 00 · FAX: (+47) 67 57 99 11